Bartscher C4431D Original-Gebrauchsanleitung Seite 60

SETTING THE PARAMETERS
LANGUAGE
To In order to select the desired language, proceed as follows:
Simultaneously press and hold the INCREASING and DECREASING keys for
4 seconds. Then press the INCREASING key until "LANGUAGE" is indicated
on the display.
Press the STEAMING key to enter the menu. Press the INCREASING and
DECREASING keys to select the desired language and confirm the selection
by pressing the START / STOP key.
Press the ON / OFF key to exit the menu.
AUTOMATIC PREHEATING
This feature is only available in the course of COOKING WITH PROGRAMS and it
means preheating of the convection oven to a temperature of 30 ° C above the
tempera-ture set in the first phase of the first program.
This function is necessary to compensate for the heat losses that occur in
the course of opening the door to be provided with food.
When starting the program the convection oven carries out this preheat cycle
(the display shows the signal "PRE"), at its end, an acoustic signal is
generated, which ends in the course of opening the door at first.
The previously selected program will start automatically in the course of closing
the door.
If the acoustic signal is to be interrupted without opening the door,
the START / STOP key must be pressed.
DEACTIVATION OF THE AUTOMATIC PREHEATING
The function of the automatic pre-heating has been set at the factory.
Simultaneously press and hold the INCREASING and DECREASING keys for
4 seconds, then press the INCREASING key until "PRE" appears in the display.
Press the STEAMING key to enter the menu. Press the INCREASING and
DECREASING keys to select the OFF option. Confirm your selection by pressing
the START / STOP key.
Subsequently, in order to activate the preheat function, follow the same steps,
as in y selection of the ON option. Press the ON / OFF key to exit the menu.
- 56 -