Installation Place - Bartscher C4431D Original-Gebrauchsanleitung

5.1.2 Installation place

•
The device must be installed in closed and well ventilated rooms (not outdoor).
•
Check the dimensions and the exact position of connections for electricity, water and
extractor connections before installation of the convection oven.
•
We recommend to install the convection oven under an extractor or to ensure the
discharge outside the hot vapours and odours which emerge from the cooking space.
•
The convection oven must be installed on a flat surface in order to prevent it from
slipping or tipping.
•
The installation surface of the convection oven must be suitable for the weight of the
device at maximum load.
•
Place the device unit on a firm, dry, water-resistant and heat-resistant surface.
The installation surface must be well accessible and big enough to be able to
operate freely with the device and to ensure good air circulation.
•
Install the device in such manner that the rear part is easily accessible in order to
allow the electricity and water connections and maintenance.
•
Should the convection oven be installed on a
fermentation cabinet, table of stainless steel or other
convection oven, it is not recommendable, to use
the higher insertions than those, at which the user
can look into the container.
•
For safety reasons, after installation
of the device, the label „Danger of
burns", which is located in the
package must be attached to the convection
oven at a height of 1600 mm from the floor
(see figure on the right).
•
Pay attention to that positioning enables a complete opening of the
convection oven door (180 ° ).
•
The device is not suitable for built-in or series installation.
•
Never install the device in the vicinity of heat sources, fryers or other sources with
hot liquids; in case this is not be possible, at least it must be kept a safety distance
laterally and above the device of 50 cm and at the back side of the device of 70 cm.
- 45 -