Electrical Connection - Harvia Pro D IP65 Bedienungsanleitung

Instructions for installation and use
1. Installing the power supply unit Pro D IP65
Perform the following steps to assembly the power unit:
1. Open the casing by loosening the screw connection of the lid.
2. Remove the lid of the Wave.com4 power unit.
3. You can affix the power unit to the underground at the 4 corners of the chassis.
ATTATION!
The cable glands must not point upwards!
After completing the connection work tighten the screw caps on the cable
glands to achieve a tight seal.

2. Electrical connection

1
2
3
4
5
6
7
Terminal strip external main switch
1
Terminal strip external light switch
2
Connection area for 230 V/400 V
3
Terminal strip for lights and fan
4
Terminal strip for power booster
5
Terminal strip for heater and power supply
6
cables, evaporator wires and additional
device
Earth rail
7
Cable gland for wires of main switch, light,
8
fan and power booster
Cable gland for power supply cable
9
Cable gland for heater cable
a
8 9 a b c
b
c
d
e
f
g
h
i
d e
Cable gland for evaporator cable
Cable gland for cable of additional output
Cable gland for remote start, safety switch off
and RJ data cable
Cable gland for F1, F2-, FTS2- and foil sensors
and status output
Function selection switches
RJ10 socket for the control panel
Terminal strip for safety switch off, remote start,
status output and sensor wires
Low-voltage connection area
p. 2/3
i
h
EN
g
f