Medtronic McGRATH MAC Gebrauchsanweisung Seite 15

3. Follow the same process as per the device cleaning section above to
intermediate-level disinfect the device. Using a new wipe, disinfect
the device, systematically working from Step 3a through Step 3g
of the device cleaning section above (from top to bottom of the
device). Ensure that the wipe comes in contact with all surfaces
of the device for the contact time recommended per the wipe
manufacturer's instructions. After reprocessing, wipe the battery
contacts.
McGRATH™ 3.6V Battery Cleaning
Clean with 70% IPA wipe
Use the following process to clean the battery:
Using a 70% IPA wipe, clean the battery, systematically working through
the following six steps (from top to bottom of the battery cover). Ensure
that the 70% IPA wipe comes in contact with all surfaces of the battery.
Ensure a minimum contact time of 1 minute on all surfaces.
• Carbon Pill: Ensure the 70% IPA wipe gets into the two button slots at
the back of the battery push button.
• Power Contact: Ensure the 70% IPA wipe gets into the space around
and under the two metal battery contacts.
• Clips: Run the 70% IPA wipe along and into the gaps around the
battery retaining clips
• Lower Battery Slot: Ensure the 70% IPA wipe gets into the lower slot at
the base of the battery
• Battery: Wipe all surfaces of the battery cover with the 70% IPA wipe
• Tab: Run the 70% IPA wipe along all surfaces of the tab.
Repeat cleaning where visible soiling is still present using a new 70% IPA
wipe. Ensure that the 70% IPA wipe comes in contact with all surfaces of
the device even if no visible soiling is present.
McGRATH™ 3.6V Battery Low-Level Disinfection
Disinfect with 70% IPA wipe
Follow the same process as per the battery cleaning section above to
low-level disinfect the battery.
Using a new 70% IPA wipe, disinfect the device, systematically working
through the six steps of the battery cleaning section instructions (from
top to bottom of the battery).
15