Speed And Distance; Overview - Beurer PM80 Gebrauchsanleitung

S
PEED AND DISTANCE

Overview

IMPORTANT: All settings in this menu only have
an effect if the Speedbox is used!
You can also use the Speedbox only to measure
your pace. Please note that the recording cannot
be transmitted to the PC. To be able to transmit,
the HR monitor needs a heart rate signal. There-
fore put the chest strap on briefly at the begin-
ning of the recording.
In the
Spd'nDist
Change the speed units. In the basic setting
[cm], you can change from [km/h] to [min/km],
in the basic setting [inch] from [mi/h] to
[min/mi].
Calibrate the Speedbox.
Specify a target distance and a target time
which you want to run during the training
session. Your HR monitor will calculate the
target speed from these values. You can have
this displayed as a target in the
menu and compared with your current training
values. In this way you can continually control
the deviations from your set target speed dur-
ing the training session.
With
speed/distances can be displayed in the bot-
tom line.
menu you can:
, information
34
on the