Steinbach Twin Originalbetriebsanleitung Seite 44

Fault description
The device does not
completely move up the wall.
The device does not function.
The device does not sink.
The device rises to the surface. The device climbs too high or
44
Cause
The filter is clogged.
Algae grows on the walls.
The water temperature is too
high or too low.
The drive belt or the cleaning
rollers are worn.
The device is too light and
topples.
The pH value and the chlorine
quantity are not properly set.
The device has too little
buoyancy.
The control unit is not
completely plugged in.
The control unit needs a
different voltage than the local
one.
There is air in the device.
The salt content is too high
and the device has more
buoyancy.
there is air trapped in the
device.
The salt content is too high
and the device has more
buoyancy.
Remedy
Clean the filters.
Clean the pool walls.
Operate the device at water
operating temperature (see
section "Technical data").
Check the drive belt and the
cleaning roller for wear and
replace them if necessary.
Switch off the device and let all
the air escape.
Adjust the pH value and the
chlorine value to the correct
value (see section "Technical
data").
Attach additional buoyancy
aids (part of the package
contents, see section
"Installing the buoyancy aids").
Check the plug connection of
the power cable and the
control unit.
Contact customer service.
Switch off the device and let all
the air escape.
Set the correct salt content.
See section "Technical data".
Switch off the device and let all
the air escape.
Set the correct salt content.
See section "Technical data".