Tilting The Work Table; Face Cutting - Holzmann HBS 470 PROFI Originalbetriebsanleitung

SETTING BLADE GUARD & GUIDE (for 60Hz)
AJUSTING THE SAW BLADE GUARD
The adjustable saw band guard should be posi-
tioned as close as possible to the workpiece. To
adjust the height, release the locking knob(D of
Fig.4.4.2 ) and turn the handwheel (E of
Fig.4.4.2) to adjust the guard up or down. Lock
the knob once the correct position of guard is
obtained. This operation must always be carried
out while the machine is stopped.
ROLLER BEARINGS BLADE GUIDE
The roller bearings should lightly touch the
blade, to prevent vibration during operation and
ensure correct direction of cutting. The position-
ing of these bearings is controlled by screw
"A"(Fig.4.6.1), once they have been adjusted,
tighten the screw "A"(Fig.4.6.1); they should be
2mm behind the teeth of the blade.The rear bear-
ing prevents excessive backward movement of
the blade whilst in operation , and should be 1-2
mm from the back of the blade.
LOWER SAW BLADE GUIDE
- To roller bearing should lightly touch the blade,
to prevent vibration during operation and ensure
correct direction of cutting. The positioning of
these rollers is controlled by screw "A"(Fig.4.6.2),
once they have been adjusted, tighten the screw
"B"(Fig.4.6.2); they should be 2 mm behind the
teeth of the blade.The thrust shaftprevents ex-
cessive backward movement of the blade whilst
in operation , and should be 1-2 mm from the
back of the blade: this can be adjusted by srew
"B"(Fig.4.6.2).

13.3 TILTING THE WORK TABLE

- To make adjustments of table tilting, slackening
the locking handle A, and rotate the shaft B with
special handle which you can find it in your loose
parts bag whith this machine. When adjustment
is correctly finished, tighten the handle A to lock
it.

13.4 FACE CUTTING

Use a square for safe guiding of the work during
face cutting.
(FIG.4.8)
HOLZMANN Maschinen Austria  www.holzmann-maschinen.at
OPERATION INSTRUCTIONS
Holzbandsäge/ Wood bandsaw
Seite 25
HBS 470PROFI