How To Activate The Rinse Aid Dispenser; Technical Data - AEG FAVORIT 88040VI Benutzerinformation

Problem
The dishes are wet and dull.

How to activate the rinse aid dispenser

1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons A and C go off.
– The indicator light for function button B continues to flash.
– The display shows the current set.
6. Press function button B again.
– The display shows the new adjustment.
7. Switch off the appliance to keep the operation.

TECHNICAL DATA

Dimensions
Water supply pressure
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of the appliance door shows the electrical connection
data.
If the hot water comes from alternative sources of energy, (e.g. solar panels, photovoltaic
panels and aeolian), use a hot water supply to decrease energy consumption.
The rinse aid dispenser is emp-
ty.
The multitab function is on.
(The rinse aid dispenser is au-
tomatically off).
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
1)
Place settings
Possible cause
Rinse aid dispenser deactivated
Rinse aid dispenser activated
Technical data
Possible solution
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispens-
er. Refer to 'How to activate
the rinse aid dispenser'.
818 - 898 mm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
63
596 mm
550 mm
12