To Clean The Spray Arms; To Clean The External Surfaces - AEG FAVORIT 88040VI Benutzerinformation

60
Care and cleaning
1. To remove filter (A), turn it counterclock-
wise and remove it out from filter (B).
2. Filter (A) has 2 parts. To disassemble the
filter, pull them apart.
3. Fully clean the parts under running water.
4. Put the 2 parts of the filter (A) together
and push. Make sure that they assemble
correctly in each other.
5. Remove the filter (B).
6. Fully clean the filter (B) under running wa-
ter.
7. Put the filter (B) to its initial position.
Make sure that it assembles correctly un-
der the two guides (C).
8. Put the filter (A) into position in filter (B)
and turn it clockwise until it locks.

To clean the spray arms

Do not remove the spray arms.
If the holes in the spray arms become clogged, remove remaining parts of soil with a
cocktail stick.

To clean the external surfaces

Clean the external surfaces of the appliance and control panel with a damp soft cloth.
Only use neutral detergents. Do not use abrasive products, scouring pads or solvents (e.g.
acetone).
B
A
C