What To Do If - AEG FAVORIT 88040VI Benutzerinformation

WHAT TO DO IF...

The appliance does not start or stops during operation.
First try to find a solution to the problem (refer to the chart). If not, contact the service
centre.
Malfunction
The appliance does
not fill with water.
The appliance does
not drain the water.
The anti-flood device
operates.
The programme does
not start.
After the check, switch on the appliance. The programme continues from the point of
interruption.
Fault code
The display
shows
The display
shows
The display
shows
Possible cause
The water tap is
blocked or is furred
with limescale.
The water pressure is
too low.
The water tap is closed. Open the water tap.
The filter in the water
inlet hose is blocked.
The connection of the
water inlet hose is not
correct.
The water inlet hose is
damaged.
There is a blockage in
the sink spigot.
The connection of the
water drain hose is
not correct.
The water drain hose
is damaged.
The appliance door is
open.
The mains plug is not
connected in.
Blow out fuse in the
household fuse box.
The delay start is set.
61
What to do if...
Possible solution
Clean the water tap.
Contact your local wa-
ter authority.
Clean the filter.
Make sure that the
connection is correct.
Make sure that the wa-
ter inlet hose has no
damages.
Clean the sink spigot.
Make sure that the
connection is correct.
Make sure that the wa-
ter drain hose has no
damages.
Close the water tap
and contact the serv-
ice centre.
Close the door correct-
ly.
Put in the mains plug.
Replace the fuse.
If you want to cancel
the delay start, refer
to 'Select and start a
washing programme'.