What To Do If - AEG F77009W0P Benutzerinformation

20

What to do if...

WHAT TO DO IF...
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the service
centre.
With some malfunctions, the display shows an alarm code:
• - The appliance does not fill with water
• - The appliance does not drain the water
• - The anti-flood device is on.
WARNING!
Deactivate the appliance before you do the checks.
Malfunction
The appliance does not fill
with water.
The appliance does not drain
the water.
The anti-flood device is on.
The start of the washing pro-
gramme does not occur.
Possible cause
The water tap is blocked or
there is limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet
hose is blocked.
The connection of the water in-
let hose is not correct.
The water inlet hose is dam-
aged.
There is a blockage in the sink
spigot.
The connection of the water
drain hose is not correct.
The water drain hose is dam-
aged.
The appliance door is open.
The door indicator is on.
You did not press the Start
touchpad or button.
The mains plug is not connec-
ted in the mains socket.
The fuse in the fuse box is dam-
aged.
Possible solution
Clean the water tap.
Contact your local water au-
thority.
Open the water tap.
Clean the filter.
Make sure that the connection
is correct.
Make sure that the water inlet
hose has no damages.
Clean the sink spigot.
Make sure that the connection
is correct.
Make sure that the water
drain hose has no damages.
Close the water tap and con-
tact the service centre.
Close the appliance door.
Press the Start touchpad or
button.
Connect the mains plug.
Replace the fuse.