To Clean The External Surfaces; What To Do If - AEG F75500VI Benutzerinformation

22

What to do if...

Removing and cleaning the upper spray arm
1. To remove the upper spray arm, turn it
laterally.
2. Clean the upper spray arm under running
water.
3. To install again the upper spray arm, put it
in position and press.
Removing and cleaning the lower spray arm
1. Turn the fixing screw (B) counterclock-
wise.
2. Pull the lower spray arm off the shaft.
3. Clean the lower spray arm and the fixing
screw under running water.
4. Put the lower spray arm in position and
turn the fixing screw clockwise.

To clean the external surfaces

Clean the external surfaces of the appliance and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or solvents (acetone).
WHAT TO DO IF...
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the service
centre.
With some malfunctions, the display shows an alarm code:
• - The appliance does not fill with water
• - The appliance does not drain the water
• - The anti-flood device is on.
WARNING!
Deactivate the appliance before you do the checks.
Malfunction
The appliance does not fill with
water.
Possible cause
The water tap is blocked or
there is limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet
hose is blocked.
Possible solution
Clean the water tap.
Contact your local water au-
thority.
Open the water tap.
Clean the filter.