Software Update - Only For Qualified Personnel - Sentiotec wave.com4 touch Montage- Und Gebrauchsanweisung

Assembling Instructions for Specialist Staff Only p. 12/20
9 Software update – only for qualified personnel
Make a note of the configuration. The settings are restored due to the software update.
The necessary data and program files are provided on request.
Proceed as follows to perform the update:
-> Switch the device on.
-> Place the USB stick with the update data into the USB port of the wave.com4 touch
Apart from the update, the USB stick must be free from other data
-> Navigate to the factory settings menu point in the technicians' menu.
-> Start the software update via a long press on C 2
-> Wait until the update is complete. Do not disconnect the device from the network under any circumstances du-
ring the software update.
->After the update the wave.com4 touch goes into standby mode.
WE DO IT FIRST.
Downloaded from www.Manualslib.com manuals search engine