Cleaning - Sentiotec wave.com4 touch Montage- Und Gebrauchsanweisung

WC4-B-L:
WC4-H-PCB:
WC4-H-H:
WC4-H-F2:
WC4-IRX-P:
WC4-SL-L:
If WC4-B-L is combined with WC4-SL-L, the WC4-SL-EXT cable set is also required. See also 'Electrical
connection – only for qualified personnel'.
wave.com4 Sauna basic modules (WC4-B-L) manufactured before 12/2011 are not compatible with the
wave.com touch. The necessary software update can only be performed at the factory.
The internal operating units are not compatible with the wave.com4 touch!
3

Cleaning

Cleaning of the operating unit
Clean the operating unit dependent on soiling.
Disconnect the entire operating unit from the network.
With a soft cloth (e.g. microfibre cloth) slightly moistened with neutral soapy water gently wipe the front of the
operating unit.
You must not clean the reverse side and the board behind under any circumstances as there is a risk of
damage to the device! Ask the service personnel if necesssary.
Due to the high temperatures and condensed water in the sauna cabin, the wave.com4 touch operating
unit is not suitable for installation in the sauna cabin.
Downloaded from www.Manualslib.com
Instructions for assembly and use
wave.com4 basic module power module
wave.com4 add-on board
wave.com4 moisture sensor
wave.com4 bench sensor
wave.com4 infra power component
wave.com4 sound&light colour lamp
WE DO IT FIRST.
manuals search engine
p. 5/20
EN