Mounting And Setting The Lens - JVC KY-F75 Bedienungsanleitung

Mounting and setting the lens

Follow the procedure shown below when mounting a motorized lens. For further details, see the
instruction manual for the lens and the lens remote control.
Camera head
Thread
section
Mount clamp ring
Lens
2.
Compatible zoom lens
Fujinon S16 × 7.3DA-DSD
1.
Remove the lens mount cap. At this time, ensure
that dust do not enter inside the mount.
2.
To mount the lens, lightly press the thread section of the lens mount onto the thread section
of the camera, and then turn the lens unit or the KY-F75 slowly clockwise until the lens is
securely threaded onto the camera.
MEMO
To change the position of the lens rotation:
First, turn the mount clamp ring clockwise (1/4 turn) as seen from the front of the lens.
Slowly turn the lens to adjust its position, and then retighten the mount clamp ring.
3.
Insert the plug of the camera cable from the lens into the [LENS] connector on the rear
panel of the KY-F75. Rotate the plug until it is securely locked.
Control of the iris is performed from the KY-F75.
4.
When connecting to the lens remote control, connect the plug (female) of the lens control
cable to the remote control.
5.
Make settings on the setting screen of the application software [KY-LINK] in accordance
with the used lens.
Iris mode settings on the Exposure and Lens setting screens (
● When using a motorized lens, set to AUTO as iris control is performed automatically.
● When using a manual lens, or for manual iris control on the camera when using a
motorized lens, set to MANUAL.
● When performing iris control with the lens remote control, set to MANUAL.
CAUTION
When using a motorized lens, supply power to the camera from an AC adapter. Control of the motorized
lens is not possible when power is supplied through the [IEEE1394] connector.
3.
Lock
(male)
4.
(female)
Lens remote control
Fujinon RMD-10
RMD-20
Lens remote
control
CAUTION
● Perform mounting of the lens with
the power of the camera turned
OFF. Mounting with the power on
could result in damage.
● Lens is not included with this
camera.
To avoid damaging the camera,
Lock
make sure that the lens mount of
the lens to be used is 4mm or less.
4 mm or
shorter
Lens
page E26, E41)
E15