Preparations; System - JVC KY-F75 Bedienungsanleitung

2. Preparations

System

The KY-F75 can be remote-controlled from a personal computer, and the live image can be
shown on the computer monitor. Still images can be captured on the PC.
When using other lenses than the motorized lens
[IEEE1394]
Supplied clamp filter
Lens
● Install the exclusive application software [KY-LINK] and drivers for KA-FW4IU that are in-
cluded on the CD-ROM supplied with KY-F75.
● Connect the [IEEE1394] connector on the KY-F75 to the IEEE1394 PCI host adapter card on
the computer using the IEEE1394 cable. Attach the clamp filter supplied with the camera to
the IEEE1394 cable.
The power to the KY-F75 can be supplied through the IEEE1394 connector of the computer.
Caution
When the KY-F75 is supplied with power though the IEEE1394 cable, make sure that the capacity on
the supplying side is sufficient to meet the consumption by the KY-F75 (approximately 600 mA in the
case of DC 12 V).
● When required, connect a flash or trigger-switch to the [REMOTE] connector. The trigger can
also be input from the screen of the application software [KY-LINK].
The flash is fired in accordance with the input from the external trigger-switch or the trigger
input from [KY-LINK]. However, in the following cases, the flash is fired irrespective of the
trigger.
● During auto-white balance operation
● When one or more of the functions Auto Iris, EEI, and ALC is/are used
E10
IEEE1394 cable
[REMOTE]
Flash
Trigger switch
CD-ROM supplied with KY-F75:
Exclusive application software
[KY-LINK] and drivers for KA-
FW4IU
IEEE1394
Host
Adapter
PC
KA-FW4IU (separately sold)