Others; Synchronizing Flash And Trigger - JVC KY-F75 Bedienungsanleitung

5. Others

Synchronizing flash and trigger

To synchronize the flash with the input of an external trigger, use the [REMOTE] connector on
the rear.
Pin configurations of connectors (
When the shutter mode is other than "RANDOM" "EEI" (
● In response to the trigger input, the KY-F75 outputs a flash signal for the CCD accumulation
period of the next frame.
● The image shot at the moment that the FLASH signal is outputted is output as the next frame.
● In the case of video output, output stops with shooting of this frame and the image on the PC's
monitor will be in the FREEZE condition.
● How to cancel the FREEZE condition can be selected. (
● The trigger interval must be minimum 3 frames (405 msec) at a shutter speed of 1/7.5 s or
faster.
● When the FREEZE cancel mode is set to "MANUAL", FLASH will not be output in response to
the trigger input for FREEZE cancellation.
Timing chart
(CCD accumulation period)
page E9).
Trigger
VD
(Internal)
EXP
FLASH
Video
output
page E28, Shutter item)
page E42, [Freeze cancel] item)
E43