Installation; Operating Instructions - lumithera VALEDA Bedienungsanleitung

8. Installation

Overview
Valeda is intended for use in a controlled room environment at ambient temperature and
humidity. See Technical Specifications on page 23.
Before unpacking Valeda, inspect the shipping box for damage. If damage is present, notify the
freight carrier and ask for an agent to be present while the system is unpacked. Retain all packing
materials in their original condition and contact LumiThera.
Box Contents
The shipping box contains the following:
• Valeda Light Delivery System
• Valeda LumiKey
• Package of Valeda Forehead Rest Protective Barriers
• Package of Valeda Chin Rest Protective Barriers
• Valeda Dust Cover
• Valeda Power Cord(s)
• Valeda Light Delivery System User Manual
• Quick Reference Guide
Valeda Setup
• Valeda should be used with chairs for the patient and operator and a height-adjustable table to
accommodate variations in patient height.
• Remove the system from the shipping box and place on the adjustable table.
• Position Valeda so that the operator can access both the patient and operator sides of the
system. The patient must be able to be comfortably seated at the patient side of the system.
• Ensure that Valeda is on a flat, hard su ace and that the side vent slots are not blocked.
• Multiple power cords may be in the box. Select the appropriate power cord for your location.
Attach the power cord to the unit and connect to a grounded outlet.
• Ensure the power cord is not a tripping hazard.
• Following hot or cold storage (below 15 or above 30°C), allow one hour for the system to reach
ambient temperature and humidity before using.

9. Operating Instructions

Operation of Valeda consists of the following steps:
• System setup
• Patient preparation
• Beam alignment procedure
• Treatment procedure
• Cleaning and storage
Valeda Setup
• Remove the dust cover.
• Verify the system has no obvious damage.
• Confirm the system is plugged into an appropriate electrical outlet and all connections are
secure. See Technical Specifications on page 23.
• Turn on the system by moving the power switch to the on position.
• Wait for the system to power on and run through the self-test. When the self-test is complete, the
home screen will appear on the touchscreen.
7