Šroub S Křížovou Hlavou M5 X - Eufab AMBER IV Bedienungsanleitung

Remove the screws from the lamp mount of the license plate holder before mounting. Insert the screws through the vertical slots of the license plate holder
(see picture). Start the screws at the threaded holes of the lamp mount, but do not tighten yet. Align the license plate folder so that it is at the same height as
the rear lights. Now tighten the screws.
5.1.7 INSERTING THE LICENSE PLATE
The mounting clips for securing the license plate are push-out parts in the holder.
Break out two of the clips. Slide the license plate into the holder, then push the
clips into the cut-outs to secure the license plate.
5.1.8 LAYING ELECTRICAL CABLES
Lay the cables along the tube of the base frame. The cables may not be bent, stretched or crushed, e.g. in the vicinity of the folding
mechanism. Secure the cables with the supplied cable ties. When you are finished, trim any excess material from the cable ties using
cutting pliers.
5.1.9 ATTACHING THE PLASTIC COVERS
Fit the plastic covers onto the middle of the wheel rails.
5.1.10 MOUNTING THE SHORT TENSIONING STRAPS
nsert the short tensioning strap from the inside to the outside below the bike holder and then from the outside to the
inside through the slots of the bike holder (see picture).
5.2 MOUNTING THE BICYCLE RACK ON THE TRAILER TOW BAR
Ensure that the trailer tow bar is undamaged, clean and free of grease.
Before you put the bicycle rack on the trailer tow bar, familiarise yourself with the
quick locking system.
The quick locking mechanism is a component with a lever. Activating the lever
opens or closes the quick locking mechanism. With the help of the securing bolt
and the padlock, the quick locking system may be locked and secured.
The padlock must always be used as additional security
when using the bicycle rack.
Park your vehicle on a level surface.
Apply the handbrake.
Remove the securing bolt from the quick locking mechanism and rotate by 90° to prevent it from engaging again. Open the quick locking mechanism by lifting
the lever.
Place the rack, from above, horizontally onto the trailer tow bar. Push the lever of the quick locking mechanism down (force required is approximately 35 - -40
kg) as far as it will go (the lever will remain in the horizontal position).
Check whether the bike rack is securely and firmly positioned on the trailer tow bar and can no longer be rotated. If this is not the case, the quick locking mecha-
nism must be readjusted. Lift the lever and remove the rack from the trailer tow bar. Remove the protective cap of the adjusting screw. Undo the lock nut of the
adjusting screw and rotate the adjusting screw on the quick locking mechanism tighter by a quarter turn. Then tighten the lock nut again.
Replace the rack back on the trailer tow bar and check whether the rack is securely and firmly positioned on the tow bar. Repeat the adjustment process until
the rack is secure and firm. Push the protective cap back onto the adjustment screw.
Caution: Always make sure that the lock nut on the adjusting screw is correctly tightened!
12
4 x Plastic cover
Clips
Cut-outs
8 x Tensioning strap, short
Lock nut
Adjusting screw for
qick locking system
Safety/locking pin
Lever
Lock