Eufab AMBER IV Bedienungsanleitung Seite 11

The general operating permit must be carried in the vehicle when the rack is mounted.
Do not travel with the bicycle rack empty. Store it in the boot of your vehicle. This prevents increased fuel consumption and
protects the rack.
The driver is always responsible for ensuring that the load and the load securing meet the regulations.
5. OPERATING INSTRUCTIONS
5.1 MOUNTING THE BICYCLE RACK
The bicycle rack must first be assembled. Take all of the components out of the packaging and set them out clearly. Every stage is described and clearly shows
which components are required for the assembly of the rack.
5.1.1 MOUNTING THE WHEEL RAILS ON THE BASE FRAME
1 x Base frame
Two wheel rails form a pair. Place four pairs of wheel rails, with the plastic shells on the outside, parallel on the base frame so that the drilled holes in the rail
match the holes in the base frame. Secure each wheel rail to the base frame with the lock screws M6 x 50, 17.8 x 6.5 x 1.1 washers and self-tapping nuts M6.
5.1.2 MOUNTING THE LAMP MOUNTS
1 x Lamp mounting set
Join the two halves of the lamp mount set together. This is made easier by the small guide element which is already mounted on one side. Push the rails together
and secure the connection with the cross-headed screw (M5x12), spring washer, washer 9.8 x 5.4 x 0.9
5.1.3 SECURING THE LIGHT MOUNT TO THE BASE FRAME
Insert the cross-headed screws M5 x 35 with spring washers and washers, from below, through the vertical drilled holes of the lamp mount. Insert the
Í
screws through the threaded holes on the underside at the end of the lamp mount. Tighten the screws.
2 x Cross-headed screw M5 x 35
2 x Spring washer 8.1 x 5.5 x 1.2
2 x Washer 9.7 x 5.3 x 0.9
5.1.4 MOUNTING THE U-BRACKET
1 x U-bracket
Now fit the U-bracket onto the intended pipe sleeves. Push the lock screws M8 x 60 from the outside, through the drilled holes of the U-bracket and the pipe
sleeves. Place the washers and knob nuts M8 on the ends of the screws and tighten the knob nuts firmly.
5.1.5 MOUNTING THE FRAME HOLDER
1 x Frame holder, wheel-to-wheel
1 x Frame holder, long
2 x Frame holder, short
Undo the handle screw of the frame holder and rotate out fully. Open the cuff of the frame holder and place the inserts around the U-bracket at a position
suitable for your bicycle. Place the cuff around the inserts and push firmly together. Close the frame holder using the handle screw (but do not tighten).
The wheel-to-wheel frame holder is only required when you secure a fourth bicycle to the rack.
5.1.6 MOUNTING THE LICENSE PLATE HOLDER
8 x Wheel rails
Í
1 x License plate holder
16 x Lock screw M6 x 50
16 x Washer 17.8 x 6.5 x 1.1
16 x Nut M6
Cross-headed screw M5 x 12
2 x Knob nut M8
2 x Washer 15.8 x 8.5 x 1.1
2 x Lock screw M8 x 60
Í
11