NEC MultiSync M-Serie Handbuch Seite 9

Introduction
products use less than 30 watts when in the main power saving mode.
The NUTEK specification 803299 requires automatic power down to
less than 30 watts in the suspend mode and less than 8 watts in the off
mode.
When in the maximum power-down mode, the MultiSync M Series
monitor will consume approximately 10% of the total power drawn
under normal operation. This innovation adds up to 90% energy savings,
longer monitor life, environmental protection, reduced emissions and
reduced air conditioning costs of the work environment. The IPM
System increases the monitor's life and saves energy and costs by
powering down when not in use.
MultiSync monitors follow the Video Electronics Standard Association
(VESA) approved DPMS power-down signalling method. VESA's
Display Power Management Signalling (DPMS) method, which is
endorsed by the EPA, is the power-down process a system should use to
communicate to the monitor to save power. Power-down functions can
be utilised only with an Energy Star system or video card which adheres
to the VESA DPMS standard. By using the monitor's horizontal and
vertical SYNC signals, the monitor can be prompted into the different
IPM modes. The following is the description of the LED indicator for
the IPM power-saving modes:
Mode
On
Stand By
Suspend
Off (IPM Mode) Orange
Off (Power
Switch, Off)
LED Indicator
Green
Green
Yellow
No Light
Power Saving
None
Minimum (Quickest Recovery)
Moderate (< 30 Watts, Moderate
Recovery)
Maximum (< 8 Watts, Slow Recovery)
No Power Used (Fully Off)
E - 3