NEC MultiSync M-Serie Handbuch Seite 23

Tools
OSM Position: You can choose where you would like the OSM image
to appear on your screen. Selecting OSM location allows you to
manually adjust the OSM menu left, right, up, or down.
OSM Turn Off: The OSM menu will stay on as long as it is in use. In
the OSM Turn Off sub-menu, you can select how long the monitor waits
after the last touch of a button to shut off the OSM menu. The preset
choices are 10, 20, 30, 60, 120 seconds.
OSM Lockout: This control completely locks out access to all OSM
functions. When attempting to activate OSM while in the lockout mode,
a screen will appear indicating that OSM is locked out. To activate the
OSM Lockout function, press PROCEED, then " " and hold down
simultanously. To de-activate the OSM Lockout, press PROCEED,
then " " and hold down simultanously.
Linearity: The Linearity selection allows you to adjust the spacing of
the areas on the screen. The purpose of this control is to ensure that a 2
cm circle is a true 2 cm circle wherever it is drawn on the screen. The
best way to determine the vertical linearity is as follows:
–
Draw equally spaced horizontal lines using a drawing
application that has a ruler.
–
Use the Vertical control to adjust the spacing between the lines
near the centre of your screen.
–
Use the Vertical Ballance control to adjust the lines near the top
and bottom of your screen.
IPM OFF MODE: Using this function to OFF MODE of the IPM can
be disabled.
–
ENABLE: The IPM works normally, all four stages of the
energy saving are used.
–
DISABLE: The OFF MODE of the IPM is not used.
For standard computers and graphics boards you should keep the factory
setting ENABLE.
Factory Preset: Selecting Factory Preset allows you to reset all OSM
settings back to the factory settings. A warning statement will appear to
confirm that you do want to reset ALL settings. Individual settings can
E - 17