NEC MultiSync M-Serie Handbuch Seite 16

E - 10
of your system. Connect the other end of the stereo-male mini
jack cable to the input located on the back of the monitor
marked "
NOTE: There is a microphone hole on the front of the
monitor marked "
microphone. This is not to be used for the input for the mini
jack cable. Please take care only to plug in the cable to the
input on the rear of the monitor, also marked "
7. Connect one end of the power cable to the MultiSync M
Series monitor and the other end to the power outlet.
8. Turn on your MultiSync monitor and computer.
9. This completes the installation.
NOTE: If you have any problems, please refer to the
Troubleshooting section of this manual.
Connection to Your Personal Computer
" located to the left of the speaker input.
". This is the location of the built-in
".