Measuring; Activating The Autohold Function; Setting Filter - Seca 655 Gebrauchsanweisung

7.2 Measuring

Activating the Autohold function

108 • seca 655/654
If you activate the Autohold function, it is no longer necessary to manually
activate the Hold function for each individual measurement procedure.
On devices with a measuring rod, the setting also applies to the height
display.
1. Press the
The Settings menu is displayed.
2. Press the
3. Select the desired setting:
4. To exit the menu, press the

Setting filter

The Filter function can be used to avoid interferences during weight determi-
nation. The selected setting has the following influences on measurements
with the Hold/Autohold function activated:
• Sensitivity with which the weight display reacts to patient movements
• Period of time until a weight value is displayed permanently.
1. Press the
The Settings menu is displayed.
2. Press the
Device mode
Basic
Advanced
Expert
Service
NOTE
This function is activated at the factory on some models. The function
can be deactivated.
key.
or key until the Autohold menu item is displayed.
– Function activated
– Function deactivated
Device mode
Basic
Advanced
Expert
Service
key.
or key until the Filter menu item is displayed.
Function available
–
•
•
•
key.
Available
–
•
•
•