Dmx-Controlled Operation; Wireless Dmx - EuroLite AKKU IP UP-4 QCL Spot WDMX Tour Set Bedienungsanleitung

DMX-controlled operation

You can control the device individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
The device has five DMX channel modes. The Control Board allows you, as described above, to assign the
DMX channel mode.

Wireless DMX

For wireless data transmission you need a DMX-controller, a wireless transmitter and a wireless receiver or
devices with built-in wireless receiver. Please use the appropriate devices from the FUTURELIGHT range.
The wireless receiver has an internal memory function. If the device is switched off and on again, the
receiver automatically logs onto the wireless transmitter.
The WDMX statuses are shown via the WDMX indicator and via the display of the LED uplight:
WDMX indicator
WDMX indicator is lit: The wireless receiver is logged into the wireless transmitter. The DMX signal is
present and received.
WDMX indicator flashes rapidly: The wireless receiver was logged into the wireless transmitter but the
WDMX transmitter is switched off or not connected to the power supply.
WDMX indicator flashes slowly: No DMX-signal, the wireless connection is on hold.
No WDMX indicator: Not logged into a wireless transmitter (free).
Display
Signal Status Display
The installation procedure of a wireless DMX system depends on the wireless sender. Please refer to the
user manual of the respective device.
Log out one wireless receiver
The device is logged out via the Control Board, menu Wireless Setting - Receive Reset - Yes.
Downloaded from www.Manualslib.com
Please note the starting address depends upon which controller is being used.
Wireless DMX setting, status
Receive ON, have DMX signal
Receive ON, without DMX signal
wireless controller is OFF
Receive ON, free
manuals search engine
Receive ON,
Receive OFF
34/40
00106659, Version 1.0