NE210
44
Downloaded from
www.Manualslib.com
6.2
Default settings
The following parameters are programmed into the counter by the
factory prior to delivery:
Preset value
Pulse contact time
Scaling factor
Start count value
Display
Inputs
Change of preset
Change of preset
C-key
6.3
Error messages
Fault must be rectified by the factory.
Fault must be rectified by the factory.
Counting frequency above 10 kHz.
After a power cut; the counter status display may be erroneous.
● Error messages
key.
7 Part number
NE210.0
www.baumer.com
manuals search engine
01000
0.25 s
01.000
00000
No decimal point
Track A and UP/DOWN
Enabled
Effective after reset
Activated
and
AX
A1
Voltage supply
1
24/48 VAC
2
85...265 VAC
3
24 VDC
Outputs
1
Relay output
2
Relay, signal output PNP
3
Relay, signal output NPN
4
Without relay, signal output PNP
can be cleared with the