Basic Operations; Operation With The Buttons On The Tv; Operation With The Remote Control; Initial Settings - Schaub Lorenz 42LT601B Bedienungsanleitung

Basic Operations

You can operate your TV using both the remote
control and onset buttons.

Operation with the Buttons on the TV

Volume Setting
• Press " " button to decrease volume or
button to increase volume, so a volume level scale
(slider) will be displayed on the screen.
Programme Selection
• Press " P/CH + " button to select the next programme or
" P/CH - " button to select the previous programme.
Viewing Main Menu
• Press " " /"
to view main menu. In the Main menu select sub-
menu using " P/CH - " or " P/CH + " buttons and enter
the sub-menu using "
To learn the usage of the menus, refer to the menu
system sections.
AV Mode
• Press the " TV/AV " button in the control panel on the
TV to switch between AV modes.

Operation with the Remote Control

• The remote control of your TV is designed to control
all the functions of the model you selected. The
functions will be described in accordance with the
menu system of your TV.
• Functions of the menu system are described in the
following sections.
Volume Setting
• Press " V +" button to increase the volume. Press "V -"
button to decrease the volume. A volume level scale
(slider) will be displayed on the screen.
Programme Selection (Previous or Next
Programme)
• Press " P - " button to select the previous
programme.
• Press " P + " button to select the next programme.
02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 70 02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 70
" buttons at the same time
" or " " buttons.
English - 70 -
Programme Selection (Direct Access)
• Press numeric buttons on the remote control to select
programmes between 0 and 9. The TV will switch
to the selected programme. To select programmes
between 10 - 299 (for IDTV) or 10-199 (for analogue),
press the numeric buttons consecutively (e.g. for
programme 27, fi rst press 2 and then 7). When the
pressing time is due for the second numeric button,
only the fi rst digit programme will be displayed. The
limit of the delay time is 3 seconds.
• Press directly the programme number to reselect
single digit programmes.

Initial Settings

When the TV set is operated for the fi rst time, the
IDTV turns on fi rst.
Because this is the fi rst time the TV is used, there are
no channels stored in the memory.
When the TV is turned on for the fi rst time, the menu
for the language selection appears on the screen. The
message "Welcome please select your language!"
is displayed in all language options sequentially in
the OSD.
By pressing the " " or " " buttons highlight the
language you want to set and press OK button. After
then, "First time installation" OSD will appear on the
screen. By pressing " " or " " buttons, select the
country you want to set and press OK button. (** for
EU countries).
Note: Country selection OSD will not be available
for UK.
After then, the active antenna selection OSD appears
on the screen:
By pressing "left cursor ikonu " or "right cursor ikonu"
buttons, set active antenna mode as on or off.
If an active antenna is connected to your TV, you
can select this option as On. Antenna power should
be "Off" when standard antenna is used instead of
the active antenna. See Confi guration Menu in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
27.05.2010 14:31:00 27.05.2010 14:31:00