Inserting Batteries Into The Remote Control Handset; Switching The Tv On/Off; To Switch The Tv On; To Switch The Tv Off - Schaub Lorenz 26LT30 Bedienungsanleitung

Inserting Batteries into the
Remote Control Handset
• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note : Remove the battery from remote control handset when
it is not to be used for a long period. Otherwise it can be
damaged due to any leakage of batteries.

Switching the TV On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC, 50
Hz.
• Press STANDBY switch. Then the standby LED
lights up.
• To switch on the TV from standby mode either:
• Press the " " button, P+ / P- or a numeric button
on the remote control.
• Press the -P/CH or P/CH+ button on the TV. The TV
will then switch on.
Note: If you switch on your TV via standby button on the
remote control, the programme/source that you were
watching last will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the " " button on the remote control or
press the STANDBY switch, so the TV will switch
to standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
02_MB45M_[GB]_3920UK_IDTV_NICKEL12_26743W_10070864_50178999.indd 53 02_MB45M_[GB]_3920UK_IDTV_NICKEL12_26743W_10070864_50178999.indd 53

Input Selection

Once you have connected external systems to your TV,
you can switch to different input sources.
• Press "SOURCE" button on your remote control for
directly changing sources.
or
• Select "Source" option from the main menu by
using " " or " " button. Use then "
" " button to highlight an input and press " " button
to select.
Note : You can mark desired source options by pressing the
OK button. Therefore, when
only the marked source options will be available (except for
the TV source).

Basic Operations

You can operate your TV using both the remote
control and onset buttons.

Operation with the Buttons on the TV

Volume Setting
• Press " " button to decrease volume or "
" button to increase volume, so a volume level scale
(slider) will be displayed on the screen.
Programme Selection
• Press " P/CH + " button to select the next programme or
" P/CH - " button to select the previous programme.
Viewing Main Menu
• Press " "/ "
to view main menu. In the Main menu select sub-
menu using " P/CH - " or " P/CH + " buttons and enter
the sub-menu using "
To learn the usage of the menus, refer to the menu
system sections.
AV Mode
• Press the " TV/AV " button in the control panel on the
TV to switch between AV modes.
English - 53 -
" or
"SOURCE"
button is pressed,
" buttons at the same time
" or " " buttons.
27.10.2010 15:39:29 27.10.2010 15:39:29