Schaub Lorenz 42LT601B Bedienungsanleitung Seite 84

OK. The following OSD message will be displayed
on the screen:
Press OK to cancel. Select Yes by pressing " " or " "
button and press OK to delete all of the channels.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight "First Time
Installation" menu item and press OK button, then
you will be asked whether or not to delete the settings.
Selecting "Yes" by pressing OK button while the "Yes"
is highlighted will delete the existing channel table.
Then you will be asked to confi rm for deleting all
channels and settings:
By selecting Yes and pressing the OK button, the
existing channel table will be deleted.
After factory settings are loaded, "First Time
Installation" menu will be displayed.
The menu which is displayed for language selection
appears on the screen at fi rst.
By pressing the " " or " " buttons highlight the
language you want to set and press OK button. After
then, "First time installation" OSD will appear on the
screen. By pressing " " or " " buttons, select the
country you want to set and press OK button (** for
EU countries).
Note: Country selection OSD will not be available
for UK.
After "First time installation" is performed, the following
message appears on the screen:
To start installation process, select "Yes", to cancel
select "No".
• To select the "Yes" or "No" option, highlight the
item by using " " or " " buttons and press the OK
button.
After then, the following OSD will be displayed on
the screen:
02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 83 02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 83
If you select CABLE option, the following screen will
be displayed:
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control.
• After this operation, you can set Search Step as
8000 KHz or 1000 KHz. If you select 1000 KHz, the
Tv will perform search process in a detailed way.
Searching duration will thus increase accordingly.
When fi nished, press OK button to start automatic
search. Automatic searching screen will be displayed
during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
If you select AERIAL option from the Search Type
screen, the digital television will search for digital
terrestrial TV broadcasts:
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
"MENU" button at any time during the process.
Note: If the digital TV fails to store any channels, "No
channels available." message will be displayed on
the screen.
Either you select AERIAL or CABLE option from the
search type menu, after the digital automatic search
English - 83 -
27.05.2010 14:31:08 27.05.2010 14:31:08