Schaub Lorenz 42LT601B Bedienungsanleitung Seite 82

Select YES to continue and Network Search screen
will be displayed. The process will then start.
During the Network Search, if channels that have
network search info are found, automatic search
process will end by locating those channels.
After search is completed, a message asking whether
to search for analogue channels appears on the
screen:
Press the OK button to search for analogue channels.
The following menu appears on the screen for
analogue channel search:
Select your Country , Language and Text language
by using " " or " " and " " or " " buttons. Press
OK or RED button to continue. To cancel, press BLUE
button. The following menu will be displayed during
the automatic tuning:
After APS is fi nalized, the programme table
will appear on the screen. In the programme
table you will see the programme numbers and names
assigned to the programmes.
If you do not accept the locations and/or the
programme names, you can change them via the
program table.
Cable Installation
Select Cable Installation line in the Installation menu
and use OK button to view the menu contents:
02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 81 02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 81
Automatic Channel Scan
Automatic channel scan is started by pressing
OK button while Automatic channel scan item is
highlighted.
The following message appears on the screen:
Highlight Yes or No by using " " or " " buttons
and press OK button to confi rm. If Yes is selected,
automatic search starts.
Selecting No cancels automatic search.
You can select frequency ranges from this screen. For
highlighting the lines you see, use " " or " " button.
You can enter the frequency range manually by using
the numeric buttons on the remote control.
• After this operation, you can set Search Step as
8000 KHz or 1000 KHz. If you select 1000 KHz, the
Tv will perform search process in a detailed way.
Searching duration will thus increase accordingly.
When fi nished, press OK button to start automatic
search.
When fi nished, press OK button to start automatic
search. Automatic searching screen will be displayed
during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
After search is completed for digital channels, a
message asking whether to search for analogue
channels appears on the screen:
Press the OK button to search for analogue channels.
The following menu appears on the screen for
analogue channel search:
English - 81 -
27.05.2010 14:31:07 27.05.2010 14:31:07