Inserting Batteries In The Remote Control Handset; Operating Range For The Remote Control; Switching The Tv On/Off; To Switch The Tv On - Schaub Lorenz 42LT601B Bedienungsanleitung

Inserting Batteries in the
Remote Control Handset
• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
Note : Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries.
Operating Range for the
Remote Control
• Point the top of the remote control toward the LCD
TV's remote sensor LED while pressing a button.
Remote range is approximately 7m/23ft.
02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 69 02_[GB]_SSM_MB35_42742W_3910UK_IDTV (DVB-TC)-PANEU_100HZ_SILVER1_10068848.indd 69

Switching the TV On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC 50
Hz.
• Press STANDBY switch. Then the standby LED
lights up.
• To switch on the TV from standby mode either:
• Press the " " button, P/CH+ / P/CH- or a numeric
button on the remote control.
• Press the -P/CH or P/CH+ button on the TV. The TV
will then switch on.
Note : If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the " " button on the remote control or
press the STANDBY switch, so the TV will switch
to standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.

Input Selection

Once you have connected external systems to your
TV, you can switch to different input sources.
• Press " S OURCE" button on your remote control for
directly changing sources.
or,
• Select " S ource" option from the main menu
by using " " or " " button. Use then " " or
" " button to highlight an input and press " " button
to select.
Note : You can mark desired source options by pressing
the OK button. Therefore, when "
pressed, only the marked source options will be available
(except for the TV source).
English - 69 -
SOURCE
" button is
27.05.2010 14:31:00 27.05.2010 14:31:00