Input Selection; Basic Operations; Operation With The Buttons On The Tv; Operation With The Remote Control - Schaub Lorenz LT22-356 DB Bedienungsanleitung

Input Selection

Once you have connected external systems to your TV, you
can switch to different input sources.
• Press "AV/SOURCE" button on your remote control for
directly changing sources.
or
• Select "Source" option from the main menu by
u s i n g " " o r " " b u t to n . U s e th e n "
" " button to highlight an input and press " " button
to select.
Note : You can mark desired source options by pressing the OK
"AV/SOURCE"
button. Therefore, when
the marked source options will be available (except for the TV
source).
Note : YPbPr mode can be use only when you connect a device that
has a YPbPr output through the PC input with YPbPr to PC cable
(YPbPr cable is not supplied).

Basic Operations

You can operate your TV using both the remote
control and onset buttons.

Operation with the Buttons on the TV

Main menu OSD cannot be displayed via control buttons.
"+/-" buttons will function as volume up/down as default.
Even if you set other functions for these buttons, "+/-"
buttons will perform as default after a short while.
Volume Setting
• Press "P/V/AV " button once and then use "+/-" buttons
to increase or decrease volume, so a volume level scale
(slider) will be displayed on the screen.
Programme Selection
• Press "+/-" to select the next or previous programme.
AV Mode
• Hold the "P/V/AV " button, source OSD will be displayed.

Operation with the Remote Control

• The remote control of your TV is designed to control all
the functions of the model you selected. The functions
will be described in accordance with the menu system
of your TV.
• Functions of the menu system are described in the
following sections.
02_MB45_[GB]_1055UK_IDTV_BRONZE11_22855W_10065354_50156390.indd 42 02_MB45_[GB]_1055UK_IDTV_BRONZE11_22855W_10065354_50156390.indd 42
Volume Setting
• Press "
" button to decrease the volume. A volume level scale
(slider) will be displayed on the screen.
Programme Selection (Previous or Next Programme)
• Press " P/Ch - " button to select the previous programme.
• Press " P/Ch + " button to select the next programme.
Programme Selection (Direct Access)
" o r
• Press numeric buttons on the remote control to select
programmes between 0 and 9. The TV will switch to the
selected programme. To select programmes between
button is pressed, only
10-500 (for IDTV) or 10-199 (for analogue), press the
numeric buttons consecutively
• Press directly the programme number to reselect single
digit programmes

Initial Settings

When the TV is turned on for the first time, the menu for the
language selection appears on the screen. The message
"Welcome please select your language!" is displayed in all
language options sequentially in the OSD.
By pressing the " " or " " buttons highlight the language
you want to set and press OK button. After then, "First time
installation" OSD will appear on the screen. By pressing "
" or " " buttons, select the country you want to set and
press OK button (* for EU countries).
Note: Country selection OSD will not be available for UK.
Press OK button on the remote control to continue and the
following message will be displayed on the screen:
• To select the "Yes" or "No" option, highlight the item by
using " " or " " buttons and press the "OK" button.
The IDTV will automatically tune to the UHF or VHF(*)
(* for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about a
few minutes.
English - 42 -
" button to increase the volume. Press "
28.09.2009 17:59:15 28.09.2009 17:59:15