Device Connected To The Mains; Device Working On Battery; Stop Treatment And Turn Off The Device; Ultrasound Coupling - Chattanooga Intelect Mobile 2 Kurzanleitung

I N T E L E C T ® M O B I L E 2 Q U I C K S TA RT G U I D E

DEVICE CONNECTED TO THE MAINS

1� Plug the Power cord into the back of device� Plug the
other end of the cord into an electrical outlet�
NOTE: The Power Cord may be unplugged from the
back of the unit in an emergency situation�
2� Turn on the ON/OFF switch located on the back of
the device�
3� Press ON/OFF button on LCD Front panel
4� Select desired function on the Home Screen

DEVICE WORKING ON BATTERY

1� Press the ON/OFF button on the LCD Front panel, as
shown below
2� Select desired function on the Home Screen (shown
below)�
ON/OFF Button
16
STOP TREATMENT AND TURN OFF THE
DEVICE
Press Play/pause button to pause treatment then press
stop on touch screen� If device is on mains power press
the on/off button on the front panel then turn off the
switch on the back of the unit�
If device is working on battery follow the above
procedure but to switch off only press the on/off
button on the front panel
PLAY/PAUSE button

ULTRASOUND COUPLING

To ensure correct operation of the Ultrasound coupling
detection, the start button must be pressed with the
applicator in air or on the holder (without gel)� After
few seconds, it can be coupled and applied on skin
with gel� Missing this step will result in coupling failure
warning message�