Operation - Ryobi ECS-1214N Bedienungsanleitung

GB
F D
ASSEMBLY
WARNING
Exercise caution when using this tool. Careless
actions, for even a fraction of a second, can
result in serious personal injury.

OPERATION

APPLICATIONS
You may use the sander for the purposes listed below:
Sanding on wood surfaces.
■
Removing rust from and sanding steel surfaces.
■
Polishing and scrubbing porcelain and metal.
■
CAUTION
Keep the cord away from the sanding pad and
position the cord so that it will not be caught on
lumber, tools, or other objects during sanding.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating this tool. Failure
to do so could result in dust, shavings, or loose
particles being thrown into your eyes, resulting in
possible serious injury.
TURNING THE SANDER ON/OFF (Fig. 4)
Follow these steps to turn the sander ON/OFF:
Turn on the sander: Push the ON/OFF switch
■
to the left.
Turn off the sander: Push the ON/OFF switch
■
to the right.
OPERATING THE SANDER (Fig. 5)
Follow these steps to operate the sander.
Secure the workpiece to prevent it from moving under
■
the sander.
WARNING
Unsecured workpieces could be thrown towards
the operator, causing injury.
WARNING
Keep your head away from the sander and the
sanding area. Your hair could be drawn into the
sander causing serious injury.
Place the sander on the workpiece so that all of the
■
sanding disc surface is in contact with the workpiece.
E I P NL S DK N FIN GR
English
Turn on the sander and move it slowly over the
■
workpiece.
Hold the sander in front and away from you, keeping
■
it clear of the workpiece. Start sander and let the
motor build to its maximum speed, then gradually
lower the sander onto the workpiece. Move the
sander slowly across the workpiece using small
circular motions.
Do not force. The weight of the unit supplies adequate
■
pressure, so let the sanding disc and sander do the
work. Applying additional pressure only slows the
motor, rapidly wears sanding disc and greatly reduces
sander speed. Excessive pressure will overload the
motor causing possible damage from motor
overheating and can result in inferior work. Any finish
or resin on wood may soften from the frictional heat.
Do not allow sanding on one spot too long as the
■
sander's rapid action may remove too much material,
making the surface uneven.
Extended periods of sanding may tend to overheat
■
the motor. If this occurs, turn sander off and wait until
sanding disc comes to a complete stop, then remove
it from workpiece. Remove your hand from vent area,
remove sanding disc, then with your hand removed
from vent area, turn sander on and run it free without
a load to cool motor.
For detail sanding such as corners and crevices,
■
use the tip of the sanding pad with small back and
forth motions, as shown in Fig. 6.
EMPTYING THE DUST BAG (Fig. 7)
For more efficient operation, empty the dust bag when it
is no more than half full. This will permit the air to flow
through the bag better. Always empty and clean the dust
bag thoroughly upon completion of a sanding operation
and before placing the sander in storage.
11
RO
H CZ RUS
CAUTION
Avoid damaging the motor from overheating, be
careful not to let your hand cover the air vents.
WARNING
Collected sanding dust from sanding surface
coatings such as polyurethanes, linseed oil, etc.
can self-ignite in your sander dust bag or
elsewhere and cause fire. To reduce the risk of
fire always empty your dust bag frequently
(10-15 minutes) while sanding and never store or
leave a sander without totally emptying its dust
bag. Also follow the recommendations of the
coatings manufacturers.
HR
PL SLO TR