Operation; Know Your Product - Ryobi R18BS Übersetzung Der Originalanleitung

particles will be produced. Use the dust collection
device or connect a dust extraction vacuum during
use. Wear respiratory protection masks containing
filters appropriate to the materials being worked.
Ensure adequate workplace ventilation. Do not
eat, drink, or smoke in the work area. Only operate
on materials which are specified in the Intended
use section. Do not operate on materials (e.g.,
asbestos) which present a health hazard.
Risk of explosion
– Accumulated fine dust may ignite and cause fire.
Keep the work area clean and free from dust. Dust
collection and vacuum extraction systems should
be regularly and thoroughly cleaned. When sanding
metal, hot sparks may be produced.
Noise and vibration
– Wear ear protection when operating the product.
Do not operate the product for extended periods of
time.
RISK REDUCTION
It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud's Syndrome
in certain individuals. Symptoms may include tingling,
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking, and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
Keep your body warm in cold weather. When operating
the product wear gloves to keep the hands and wrists
contributing to Raynaud's Syndrome.
After each period of operation, exercise to increase
blood circulation.
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.

OPERATION

Do not operate the product without a properly tracked
and fitted belt. An incorrectly tracked belt may come off
sander.
Secure the workpiece with a vice or clamp to a suitable
work bench. This helps to prevent the workpiece
2 | English
Use the supplied handles to hold and control the
product with both hands.
Do not force the product. Use the correct product for
better and safer at the rate for which it is designed.
Do not apply excessive pressure to the product. Let the
weight of the product apply the correct pressure and use
your hands to guide the sander. Excessive pressure will
overload the product and damage the motor. Applying
more pressure will not remove more material and will
reduce sanding efficiency instead.
Change the sanding belt often to maintain the product's
ability to effectively remove material.
Start the product using the trigger switch and allow the
belt to gain correct speed. Then lower the belt onto the
workpiece. Hold the product securely in both hands
because the movement of the belt will drive the product
forwards.
Choose a belt of the correct size and appropriate
roughness for the task. Use belts with a lower grit
number for removing more material; higher grit number
for removing less material and for a finer finish. Replace
the belt if it becomes damaged, clogged with debris,
or is worn.
It is normal to sand and move the product back and
forth along the grain of the material. Sanding across
the grain will work but it results to a scratched and
damaged surface.
WARNING
Dust from certain paints, coatings, and materials may
cause irritation or allergic reactions to the respiratory
system. Dust from wood, such as oak, beech, MDF, and
others are carcinogenic. Materials containing asbestos
specialist operators.
Use the dust collector or connect the dust port to a
vacuum device to reduce risks associated with dust
particles.
All persons within the work area or nearby should wear
dust masks which offer appropriate protection.
Always wear safety goggles or safety glasses with side
shields when operating power tools.
WARNING
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.

KNOW YOUR PRODUCT

See page 107.
1. Front handle
2. Lock on button
3. Main handle