Ryobi ECS-1214N Bedienungsanleitung Seite 14

GB
F D
FEATURES
KNOW YOUR COMPACT FINISHING SANDER (Fig. 1)
Before using this product, familiarize yourself with all
operating features and safety requirements. However,
do not let familiarity with the tool make you careless.
SWITCH (1)
This tool is equipped with a simple switch control located
near the front of the motor housing.
QUICK CHANGE HOOK AND LOOP PAD (2)
The hook and loop design allows for quick change of
sanding sheets and scrubbing pads. It also enables you
to easily clean and reuse them.
TRI-FLEX PAD DESIGN
The top two-thirds of each sanding pad is a detachable
triangle that can be rotated to extend pad life and
promote even wear.
CIRCULAR SANDING ACTION
The oscillating action of your sander produces very quick,
small circular motion of the sanding pad. The motion is
ideal for producing a fine finished grain or, when using
the scrubbing pad, removing light rust, paint and other
build up from the work surface.
DUST COLLECTION BAG (3)
The dust bag attaches to the sander and keeps dust
to a minimum.
PAPER PUNCH (4)
The paper punch template punches sandpaper (5) for
proper fit and alignment.
ASSEMBLY
WARNING
The tool should never be connected to a power
supply when you are assembling parts, making
adjustments, cleaning, performing maintenance,
or when the tool is not in use. Disconnecting the
tool will prevent accidental starting that could
cause serious injury.
SANDING DISC SELECTION
Selecting the correct size, grit and type of sand paper is
extremely important step in achieving a high quality
sanded finish.
E I P NL S DK N FIN GR
English
Aluminum oxide, silicon carbide, and other synthetic
abrasives are best for power sanding. Natural abrasives,
such as flint and garnet are too soft for economical use in
power sanding.
In general, coarse grit will remove the most material and
finer grit will produce the best finish in all sanding
operations. The condition of the surface to be sanded will
determine which grit will do the job. If the surface is
rough, start with a coarse grit and sand until the surface
is uniform. Medium grit may then be used to remove
scratches left by the coarser grit and finer grit used for
finishing of the surface. Always continue sanding with
each grit until surface is uniform.
Sheet/Pad
80-grit sanding sheet
100-grit sanding sheet
150-grit sanding sheet
ATTACHING HOOK AND LOOP SANDING DISCS
(Fig. 2)
Unplug the sander.
■
Align holes in hook and loop type sanding disc with
■
holes in pad, then carefully press fuzzy side of
sanding disc against pad as tightly as possible.
Note: Hook and loop type sanding discs can be
reused for the life of the sanding abrasive. It is
recommended that you keep the sanding disc backing
pad clean to provide for best adhesion. Clean
occasionally by brushing lightly with a small brush.
ATTACHING THE DUST BAG (Fig. 3)
The dust bag provides a dust collection system for the
sander. Sanding dust is drawn up through the holes of the
sanding disc and collected in the dust bag during sanding.
Follow these steps to attach the dust bag.
Unplug the sander.
■
Using a slight twisting motion as shown in figure 3,
■
firmly slide dust bag assembly in blower exhaust
on sander.
10
RO
H CZ RUS
Recommended Use
Coarse sanding
Light sanding
Light sanding
WARNING
The sander should never be connected to a
power supply when you are assembling parts,
making adjustments, cleaning, perfor ming
maintenance, or when the tool is not in use.
Disconnecting the tool will prevent accidental
starting that could cause serious injury.
HR
PL SLO TR