Specification; Operation - Ryobi ERO-2412v Bedienungsanleitung

GB
F D
SPECIFIC SAFETY RULES FOR SANDERS
WARNING
Do not throw sanding dust on an open fire because
materials in fine particle form may be explosive.
WARNING
A suitable breathing respirator must be worn
while sanding lead paint, some woods and metal
to avoid breathing the harmful/toxic dust or air.

SPECIFICATION

Input
Wattage
No load speed
Orbital diameter
Pad size
APPLICATIONS
Use only for the purposes listed below:
Sanding on wood surfaces.
Removing rust from and sanding steel surfaces.
Sanding plastics.
DESCRIPTION
1. Switch
2. Velcro adhesive pad
3. Dust bag assembly
4. Speed select dial
5. Dust bag frame
6. Dust bag
FEATURES
Your sander is suitable for sanding with coarse, medium,
and fine grit sandpaper. It will produce a fine scratch free
finish when used to sand with the grain on wood surfaces.
Your sander has a comfortable palm grip handle that
provides maximum one-hand comfort, and reduces
operator fatigue during continuous sanding operations.
Your sander also has a built in dust collection that
collects dust through punched holes in the sandpaper
and cushion (Fig. 2).
Before attempting to use your sander, familiarize yourself
with all operating features and safety requirements.
E I P NL
230 V ~ 50 Hz
240 W
-
1
7000 min - 12000 min
2.5 mm
125 mm
S DK N FIN
English
SWITCH (1)
This tool is equipped with a simple switch control. To turn
the sander "ON", slide the switch to the left.
Slide the switch to the right to turn the sander "OFF".
ELECTRONIC SPEED CONTROL (4)
The electronic speed control allows the operator to adjust
speed to meet varity sanding material from tough heavy
grained timber to delicate veneer.
WARNING
Do not allow familiarity with your sander to make
you careless. Remember, a careless fraction of a
-
1
second is sufficient to inflict severe injury.

OPERATION

WARNING
Your sander should never be connected to power
supply when you are assembling parts, making
adjustments, assembling or replacing sandpaper,
cleaning, or when not in use. Disconnecting
sander will prevent accidental starting that could
cause serious personal injury.
INSTALLING ADHESIVE SANDPAPER
Inspect sandpaper before installing. DO NOT use
broken or defective sandpaper.
Unplug your sander.
WARNING
Failure to unplug your sander could result in
accidental starting causing possible serious
personal injury.
If replacing sandpaper, remove old sandpaper by
peeling it off.
Holes in sand paper must line up with holes in
backing pad in order for the dust collection feature of
your sander to function properly.
Note: DO NOT use sander without sandpaper. Doing so
will damage the cushion.
PREPARING FOR OPERATION
CAUTION
Be careful not to let your hand completely cover
air vents.
6
GR H CZ RUS RO PL