Panasonic ES‑LV97 Betriebsanleitung Seite 20

• See page 21 for removing the outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
Attach the outer foil
section and dry with the
self-cleaning recharger
[B]�
1. Insert the shaver into the
self‑cleaning recharger and
plug the adaptor into a
household outlet.
• Check that the charge status lamp ( ) is
glowing.
2. Press twice.
The DRY lamp glows, and the "Dry/Charge"
mode will start after approximately 6 seconds.
• It is possible to change to the "AUTO" mode
even after the "Dry/Charge" mode has started.
Dry
180 min
3. Remove the adaptor after the selected mode is
completed.
5
Lubricate the shaver�
20
ES-LV97_EU.indb 20
1
1
2
Charge
0 to 60 min
It will keep the movement of the blade smooth and
maintain a comfort shave.
1. Apply one drop of oil to each of the system outer
foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
five seconds.
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
► Drying the shaver without the self-cleaning recharger
Dry in a shade and apply oil.
Notes
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or
discoloration of the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
2019/06/05 21:17:22