Vehicle Connection & Charging; Socket Equipped Model; Vehicle Connection - VESTEL EVC04 Serie Benutzerhandbuch

1.3.3 - VEHICLE CONNECTION & CHARGING
After configuring your charger with smart application, you can control the charger via the applica-
tion either in autostart mode or in RFID authorised mode. Autostart and RFID authorised modes
are explained in section 1.1 and 1.2.
Your charging station behaves in autostart charging mode as mentioned below. But you can
continue to control the charger with smart application even it is in autostart charging mode.
a) If you do not make any configuration in configuration mode for 60 seconds and con-
nect your charging cable, your charging station starts in autostart mode automatically.
b) If you delete the last RFID card from the local RFID card list, then your charger starts
to behave as autostart mode. (Detailly descriped in section 1.2.1.1 )

1.3.3.1 - SOCKET EQUIPPED MODEL

1.3.3.1.1 - VEHICLE CONNECTION & CHARGING
Model Without Display
1 - Ensure that your vehicle and the station is
ready for charging.
2 - Insert the charging plug to the vehicle
inlet and charging station socket outlet.
No LED Indication
IB v7.3.0 2020
No LED Indication
© 2020 Vestel - All rights reserved
Model With Display
1 - Ensure that your vehicle and the station is
ready for charging.
No LED Indication
2 - Insert the charging plug to the vehicle
inlet and charging station socket outlet.
No LED Indication
English - 25