Safety Information; Safety Warnings; Ground Connection Warnings; Power Cords, Plugs And Charging Cable Warnings - VESTEL AC 3-Phase 22kW Benutzerhandbuch

SAFETY INFORMATION

CAUTION
RISK OF ELECTRIC SHOCK
CAUTION :
VESTEL EV CHARGER MUST BE INSTALLED ONLY
BY A LICENSED AND EXPERIENCED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE LOCAL AND
NATIONAL ELECTRICAL CODES AND STANDARDS.
CAUTION
EV charger AC mains supply con-
nection and load planning must be
analyzed and approved by authori-
zed personnel in accordance with all
applicable local and national electrical
codes and standards. For multiple EV charger installations, the load
planning must be evaluated accordingly. The manufacturer is not
responsible or liable, directly or indirectly, in any way for any da-
mage and risks caused by the incorrect AC mains supply and load
IMPORTANT - Please read these
instructions fully before installing or
operating

SAFETY WARNINGS

• Keep this manual in a safe place. These safety
and operating instructions must be kept in a
safe place for future reference.
• Check that the voltage marked on the rating
label and do not use charging station without
appropriate mains voltage.
• Do not continue to operate the unit if you are
in any doubt about it working normally, or if it
is damaged in any way - switch off the mains
supply circuit breakers (MCB and RCCB).
Consult your local dealer.
• The ambient temperature range during
charging should be between –30 °C and +50
°C and at a relative humidity of between 5 %
and 95 %. Use the charging station only within
these specified operating parameters.
• The charging station is intended for outdoor
and indoor use but which may also be used in
public places.
• To reduce the risk of fire, electric shock or
product damage, do not expose this unit to
severe rain, snow, electrical storm or other
severe weathers. Moreover, the charging
station shall not be exposed to spilled or
splashed liquids.
• Do not touch end terminals, electric vehicle
connector and other hazardous live parts
of the charging station with sharp metallic
objects.
planning.
• Avoid exposure to heat sources and place the
unit well away from near flammable, explosive,
harsh, or combustible materials, chemicals, or
vapors.
• Risk of Explosion. This equipment has internal
arcing or sparking parts which should not be
exposed to flammable vapors. It should not be
located in a recessed area or below floor level.
• This device is intended only for charging
vehicles not requiring ventilation during
charging.
• To prevent risk of explosion and electric shock,
ensure that the specified Circuit Breaker and
RCD are connected to building grid.
• The lowest part of the socket-outlet shall be
located at a height between 0,4 m and 1,5 m
above ground level.
WARNING: Never let people (including
children) with reduced physical, sensory or
mental capabilities or lack of experience
and or knowledge use electrical devices
unsupervised.

GROUND CONNECTION WARNINGS

• The Electric Vehicle Charger (EVC) must be
connected to a centrally grounded system.
The ground conductor entering the EVC must
be connected to the equipment grounding
lug inside the charger. This should be run
with circuit conductors and connected to the
equipment grounding bar or lead on the EVC.
Connections to the EVC are the responsibility
of the installer and purchaser.
• To reduce the risk of electrical shock, connect
only to properly grounded outlets.
POWER CORDS, PLUGS and
CHARGING CABLE WARNINGS
• Be sure that vehicle charge cable is Type 2
socket compatible on charging station side.
• A damaged power cord/plug or EV cable can
cause fire or give you an electric shock. Do not
use this product if the flexible power cord or
EV cable is frayed, has broken insulation, or
shows any other signs of damage.
• Ensure that the charge cable is well positioned
thus; it will not be stepped on, tripped over, or
subjected to damage or stress.
• Do not forcefully pull the charge cable or
damage it with sharp objects.
English - 2 -