LOCKED CABLE FUNCTION (Model with Socket)
The cable becomes locked and your socket model charging station starts behaving as an
attached cable model.
1-
Turn off the power of your charging station.
3-
To enable locked cable function, toggle DIP switch
pin 3 to ON position using pointed spudger or a
plastic pointed tool. The DIP switch location is as
shown in below figure.
1
5-
Open the front cover of the socket outlet and plug
the charging cable to the socket outlet.
IB v7.3.0 2020
Enabled
ON
1
2
3
4
5
6
Disabled
2
3
© 2020 Vestel - All rights reserved
2-
Open the product cover as described in the
installation manual.
4-
Close the product cover as described in the
installation manual.
6-
Turn on the power to your charging station. The
cable becomes locked and the charging station starts
behaving as an attached cable model.
English - 47