Control Techniques Leroy-Somer Unidrive M200 Schritt-Für-Schritt-Anleitung Seite 8

Table 7-1 Recommended torque settings
Model size
All
8 and 9
STEP 8: Wire the drive up
M200/M300: The wiring diagram is for use with the default drive configuration (Pr 05 set to AV) which is frequency
control via Analog Input 1 (0-10 V) or Analog Input 2 (0-10 V) selected by terminal 14.
M201: The default setting uses the onboard Speed Ref Potentiometer rather than the analog input for the frequency
reference (only the drive enable terminal is required).
Figure 8-1
Figure 8-2
Zero frequency
Drive enable
Run forward
Run reverse
Analog input 1/
Analog input 2 select
* Not required on Unidrive M201 since the Speed Ref Potentiometer is already on the product. The Run/Stop
commands are given from the keypad and if reverse direction is needed, the user should set Pr 17 to On.
** 250 Vac maximum (UL class 1).
*** Unidrive M300 uses Safe Torque Off (drive enable) inputs and terminal 11 is unassigned.
Refer to section 4.1 in the Control Quick Start Guide for information and wiring diagrams for alternative
configurations.
An external braking resistor can be connected if required. Refer to Chapter 4 in the Power Installation Guide for
further details.
8
Downloaded from www.Manualslib.com
Terminal description
Control terminals
Power terminals
5
Ground terminals
6 Power and ground terminals
7 Power and ground terminals
Power and ground terminals
Power terminal connections
3 ph
AC power
supply
Unidrive M200/M201/M300 control terminal connections
Digital I/O
24 V user
Digital I/O1
Digital Input 2
***
Digital input 3
*
Digital input 4
*
Digital input 5
*
**
Relay 1
Drive ok
manuals search engine
Relay terminals
AC supply
L1 U
L2 V
W
L3
Analog I/O
0V
9 1
Analog input 1
10 2
10 V user
11 4
Analog input 2
12 5
Analog output 1
13
7
14
41
42
24 V user
Unidrive M200/M201/M300 Step By Step Guide
Torque settings
0.2 N m (0.15 lb ft)
0.5 N m (0.37 lb ft)
1.5 N m (1.1 lb ft)
2.0 N m (1.4 lb ft)
6.0 N m (4.4 lb ft)
12 N m (8.85 lb ft)
15 N m (11.1 lb ft)
Motor
Frequency
10 kW
reference 1
Frequency
10 kW
reference 2
Frequency output
M300 only
Safe Torque
Off
S 01 T
31
0V 0V
STO1
32
0V
STO2
36
S 02 T
35
Issue Number: 1
*
*