Technical Specifications; General Safety Instructions For Compressed-Air Tools - Parkside IAN 339157_1910 Originalbetriebsanleitung

Technical specifications

Rated air pressure
Air consumption
Max . rotation speed
Tool fitting
Noise emission values
Noise measurement determined in accordance
with ISO 15744
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear hearing protection!
Vibration emission value
Vibration values determined in accordance with
ISO 28927-5 and EN 12096:
Uncertainty
WARNING!
► The noise emission levels specified in these
instructions have been measured in ac-
cordance with the standardised measuring
procedure specified in ISO 15744 and can
be used to make equipment comparisons .
The noise emission values vary in accordance
with the use of the compressed-air tool and
may be higher than the values specified in
these instructions in some cases . It is easy to
underestimate the noise emission load if the
compressed-air tool is used regularly in a
certain manner .
NOTE
► For an accurate estimate of the noise emission
load during a certain working period, the
times during which the tool is switched off or
is running but not actually being used must
also be taken into consideration . This can
significantly reduce the noise emission load
over the total working period .
PDBS 1800 A1
max . 6 .8 bar
720 l/min
max . 1800 rpm
max . Ø 10 mm
(wheel-rim chuck)
L = 87 .9 dB (A)
pA
K = 3 dB
pA
L = 98 .9 dB (A)
WA
K = 3 dB
WA
a = 0 .98 m/s
2
h
K = 0 .59 m/s
2
General safety
WARNING!
instructions for
compressed-air tools
WARNING!
► Read all safety warnings and all instruc-
tions. Failure to follow the warnings and
instructions may result in electric shock, fire
and/or serious injury .
NOTE
► The terms "compressed-air tool" or "tool"
used in the following text refer to the com-
pressed-air tools specified in these operating
instructions .
Save all warnings and instructions for future
reference.
■ The user must evaluate the specific risks that
may arise due to different kinds of use .
■ Please ensure that you have read and under-
stood the safety instructions before fitting,
operating, repairing, servicing or replacing
any accessories and before working near the
compressed-air tool . Failure to do this can result
in serious bodily injury .
■ The compressed-air tool should only be set up,
adjusted or used by adequately qualified and
trained operators .
■ The compressed-air tool may not be modified .
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator .
GB │ MT │ 35 ■