Hazards in the workplace
■
Slipping, tripping up and falling are the main
causes of injuries in the workplace . Pay atten-
tion to surfaces that may have become slippery
from the use of the machine and also be aware
of tripping hazards caused by air or hydraulic
hoses .
■
Proceed with caution in unknown surroundings .
Hidden hazards caused by power or other
supply lines may be present .
■
This compressed-air tool is not suitable for use
in explosive atmospheres and is not insulated
against contact with power sources .
■
Ensure that there are no electric mains, gas
pipes, etc . that might result in a hazard if dam-
aged by using the machine .
■
Make sure (e .g . by using a metal detector) that
there are no hidden power, water or gas lines in
the location where you are working .
Hazards caused by dust and vapours
■
The dusts and vapours produced by using the
machines for screw connections can be hazard-
ous to health (e .g . cause cancer, birth defects,
asthma and/or dermatitis); it is essential to
carry out a risk assessment in respect of these
risks and to implement corresponding regulato-
ry mechanisms .
■
The risk assessment should include the dust
caused by using the machine and any existing
dust that may be raised at the same time .
■
The exhaust air should be extracted so that the
minimum amount of dust is raised in an already
dusty environment .
■
If dusts or vapours are created, the main priority
must be to control these at the site of their
release .
PDBS 1800 A1
■
All machine components or accessories intended
for collecting, extracting or suppressing airborne
dust or vapours or should be used and serviced
properly in accordance with the manufacturer's
instructions .
■
Consumables/machine tools should be selected,
maintained and replaced in accordance with
the recommendations in this guide in order to
avoid unnecessary intensification of dust or
vapour production .
■
Use a dust mask as per the instructions provided
by your employer or as required by health and
safety regulations .
■
Working with certain materials can lead to
emissions of dust and vapours that are poten-
tially explosive .
Hazards caused by noise
■
Excessive noise levels in conjunction with insuffi-
cient hearing protection may lead to permanent
hearing damage, loss of hearing and other
problems, such as tinnitus (ringing, buzzing,
whistling or humming in your ears) . It is essential
to carry out a risk assessment with regard to
these hazards and implement suitable control
mechanisms .
■
Suitable control mechanisms include measures
such as the use of insulating materials to avoid
ringing noises from occurring on the workpieces .
■
Use hearing protection according to the
instructions provided by your employer and as
required by work and health safety regulations .
■
The automatic screwdriver is to be operated
and maintained in accordance with the recom-
mendations contained in this manual in order to
reduce any unnecessary increase of the noise
levels .
GB │ MT
│
41
■