Technical Specifications - Parkside PWBSA 12 A1 Originalbetriebsanleitung

Technical specifications

Cordless Angle Drill 12V PWBSA 12 A1
Rated voltage
Rated idling speed
Max . torque hard/soft bolting according to
ISO 5393
Chuck capacity
Max . drill diameter
Max . screw diameter
Battery pack PAPK 12 A3*
Type
Rated voltage
Capacity
High-speed battery charger PLGK 12 A2*
INPUT
Rated current
Rated power
consumption
Fuse (internal)
OUTPUT
Rated voltage
Rated current
Charging time
Protection class
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise emission values
Noise measurement value determined in accordance
with EN 62841 . The A­rated noise level of the power
tool at the working location is typically as follows:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
PWBSA 12 A1
12 V (DC)
n 0–1300 rpm
0
11/3 Nm
Ø max . 10 mm
10 mm for steel
10 mm for wood
6 mm
LITHIUM ION
12 V (DC)
2000 mAh/24 Wh
220–240 V ∼,
50–60 Hz (AC)
50 W
2 A
T2A
12 V (DC)
2400 mA
approx . 60 min
II / (double insulation)
L = 75 .3 dB (A)
pA
K = 5 dB
pA
L = 86 .3 dB (A)
WA
K = 5 dB
WA
Wear ear muffs!
Total vibration values (vector total of three direc­
tions) determined in accordance with EN 62841:
Drilling in metal
Uncertainty
Screwing
Uncertainty
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with another
tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
► Depending on the manner in which the power
tool is being used and, in particular, the kind
of workpiece being worked, the vibration and
noise emission values can deviate from the
values given in these instructions during actual
use of the power tool .
► Try to keep the vibration load as low as
pos sible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation
must be included (e .g . times when the power
tool is switched off and times where the power
tool is switched on but running without load) .
a = 3 .96 m/s
2
h,D
K = 1 .5 m/s
2
a = 3 .5 m/s
2
h,D
K = 1 .5 m/s
2
GB │ MT │ 51 ■