Optional Accessories; Protecting The Environment; Rechargeable Battery Pack - DeWalt XR FLEX VOLT LI-ION DCS575 Bersetzt Von Den Originalanweisungen

ADJUSTING BEVEL ADJUSTMENT LEVER (FIG. 29)
It may be desirable to adjust the bevel adjustment
lever (G). It may loosen in time and hit the base
plate before tighten ing.
To Tighten the Lever:
1. Hold the bevel adjustment lever (G) and loosen
the bevel locknut (AO).
2. Adjust the bevel adjustment lever by rotating
it in the desired direction about 1/8 of a
revolution.
3. Retighten nut.
Blades
A dull blade will cause inefficient cutting, overload
on the saw motor, excessive splintering and
increase the possibility of kickback. Change blades
when it is no longer easy to push the saw through
the cut, when the motor is straining, or when
excessive heat is built up in the blade. It is a good
practice to keep extra blades on hand so that
sharp blades are available for immediate use. Dull
blades can be sharpened in most areas.
Hardened gum on the blade can be removed with
kerosene, turpentine, or oven cleaner. Anti-stick
coated blades can be used in applications where
excessive build-up is encountered, such as pressure
treated and green lumber.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury,
only D WALT recommended accessories
e
should be used with this product.
DO NOT USE WATER FEED ATTACHMENTS WITH
THIS SAW.
VISUALLY EXAMINE CARBIDE BLADES BEFORE
USE. REPLACE IF DAMAGED.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and
batteries marked with this symbol must
not be disposed of with normal household
waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for
raw materials. Please recycle electrical products
and batteries according to local provisions. Further
information is available at www.2helpU.com.

Rechargeable Battery Pack

This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely, then
remove it from the tool.
• Lithium-ion cells are recyclable. Take them to
your dealer or a local recycling station. The
collected battery packs will be recycled or
disposed of properly.
WALT, have not
e
english
69