Screw Anchor Pull-Out Forces - Paramondo Miray 1000 Montageanleitung

18
Dübelauszugskräfte • Screw anchor pull-out forces
EN

Screw anchor pull-out forces

Pull-out forces state the force required for pulling a screw out of the wall. No difference is
made between the screw plus screw anchor coming out of the wall, the screw breaking or
the brickwork failing.
The pull-out forces state the maximum tensile force that may be exerted on the screw and/
or screw anchor.
The fixing material must be selected to match the fitting base, type of fitting and pull-out
forces.
Screw anchor pull-out force of
the attachment (kN)
100
150
XXX
cm 200
250
Screw anchor pull-out force of
the attachment (kN)
100
150
XXX
cm 200
250
The values in the table are stated in kN and express the pull-out force of the anchor (screw /
screw anchor) which is subjected to the highest tension.
The values are calculated for an anchor in unbroken concrete.
The selection of the most suitable fixing material depends on the type of fitting base and its
physical condition. The fitter is responsible for checking the fitting base prior to fitting the
awning.
The screw anchor pull-out forces are calculated on the basis of Wind Resistance Class 1 in
accordance with the EN 13561 and EN 1932 standards.
INSTALLATION OF WALL BRACKET
100 150
0,04 0,05
0,05 0,06
0,05 0,06
0,06 0,07
INSTALLATION OF BOTTOM PLATE
100 150
0,69 0,77
1,12 1,30
1,60 1,92
2,14 2,64
www.paramondo.de
XXX
cm
200 250 300
0,06
0,07 0,08
0,07 0,09 0,10
0,08 0,10 0,12
XXX
cm
200 250 300
0,86
1,50 1,74
2,29 2,70 3,16
3,22 3,86 4,57
350
0,12
0,14
350
3,65
5,34