Srew Anchor Pull-Out Forces - Paramondo Pergorama 4000 Montageanleitung

66
Screw anchor pull-out forces
Screw anchor pull-out forces
Pull-out forces state the force required for
pulling a screw out of the wall. No difference
is made between the screw plus screw an-
chor coming out of the wall, the screw brea-
king or the brickwork failing.
The pull-out forces state the maximum ten-
sile force that may be exerted on the screw
and/or screw anchor.
The fixing material must be selected to
match the fitting base, type of fitting and
pull-out forces.
The values in the table are stated in kN and
express the pull-out force of the anchor
(screw / screw anchor) which is subjected to
the highest tension.
Extraction load on anchoring devices
(kN)
100 cm
200 cm
XXX
cm
300 cm
400 cm
Extraction load on anchoring devices
(kN)
100 cm
200 cm
XXX
cm
300 cm
400 cm
WALL INSTALLATION
100 cm
0,014
0,028
0,043
0,057
FLOOR INSTALLATION
100 cm
0,023
0,045
0,068
0,090
www.paramondo.de
The selection of the most suitable fixing ma-
terial depends on the type of fitting base and
its physical condition. The fitter is responsib-
le for checking the fitting base prior to fitting
the awning.
The screw anchor pull-out forces are calcu-
lated on the basis of Wind Resistance Class
1 in accordance with the EN 13561 and EN
1932 standards.
XXX
cm
200 cm 300 cm
0,048 0,103
0,097 0,205
0,145 0,308
0,194 0,411
XXX
cm
200 cm 300 cm
0,085 0,188
0,170 0,375
0,255 0,563
0,340 0,750
400 cm 500 cm
0,177 0,271
0,354 0,542
0,531 0,814
0,708 1,085
400 cm 500 cm
0,330 0,513
0,660 1,025
0,990 1,538
1,320 2,050