Screw Anchor Pull-Out Forces - Paramondo Tholos V1 Montageanleitung

18
Dübelauszugskräfte • Screw anchor pull-out forces
EN

Screw anchor pull-out forces

Pull-out forces state the force required for pulling a screw out of the wall. No difference is
made between the screw plus screw anchor coming out of the wall, the screw breaking or
the brickwork failing. In the case of the baldachin awning, the anchor pull-out forces are
based on the floor anchoring.
The pull-out forces state the maximum tensile force that may be exerted on the screw and/
or screw anchor.
The fixing material must be selected to match the fitting base, type of fitting and pull-out
forces.
Screw anchor pull-out force of
the attachment (kN)
250
300
XXX
cm 350
400
The values in the table are stated in kN and express the pull-out force of the anchor (screw /
screw anchor) which is subjected to the highest tension.
The selection of the most suitable fixing material depends on the type of fitting base and its
physical condition. The fitter is responsible for checking the fitting base prior to fitting the
awning.
The screw anchor pull-out forces are calculated on the basis of Wind Resistance Class of the
awning in accordance with the EN 13561 and EN 1932 standards.
BOTTOM INSTALLATION
250
0,04
0,05
0,06
0,07
www.paramondo.de
XXX
cm
300 350
0,05 0,06
0,06 0,07
0,07 0,08
0,08 0,09
400
0,07
0,08
0,09
0,11