Wind Resistance Classes - Paramondo Miray 1000 Montageanleitung

16
Windwiderstandsklassen • Wind resistance classes
EN

Wind resistance classes

The awning meets Wind Resistance Class 1.
The awning has a wind resistance class of 1
and must be retracted in case the wind force
is higher than 4.
The awning manufacturers must test their
products for wind resistance and declare the
correct wind resistance class. DIN EN 13561
defines corresponding wind resistance clas-
ses with their allocated wind forces accor-
ding to Beaufort. If no test has been perfor-
med and/or Wind Resistance Class 1 has not
been reached, the awning must be given
Wind Resistance Class 0.
The following table shows the wind resistan-
ce classes in accordance with DIN EN 13561
and their allocated wind forces according to
Beaufort.
Wind resistance class
Wind force according to
Beaufort
Wind speed (Vmax. (km/h))
Wind speed (Vmax. (m/s))
Dynamic pressure created
by wind (q(N/m2)
Source: DIN EN 13561 awnings
0 1 2
< 4 4 5
< 28 28 38 49
< 7,8 7,8 10,6 13,6
< 40 40 70 110
www.paramondo.de
Use of awnings in windy regions
When using motorised awnings in
windy regions or in regions with fre-
quent power cuts, it is recommended to use
motors with a manual emergency crank or
emergency power supply.
Motorised awnings without a manual emer-
gency crank or emergency power supply
cannot be retracted during a power cut and
could therefore be severely damaged or
destroyed!
Legend:
3
6